Details

The 5020M is widely used in medium and maximum security detention facilities for remotely controlled electric unlocking of inmate room and passage doors.

This lock is ideal as a component in attack resistant security perimeters in sensitive areas of commercial, governmental, and industrial buildings.

• High Security and Impact Resistant – 1” Throw.

• 24 VDC or 120 VAC Motor Power.

• Manual Key Unlocking – Jamb Mounted.

Standard Features

• Electric unlocking is by either 24VDC or 120VAC motor.
  • Latch retraction is quiet and capable of overcoming abnormally high side loads (e.g. someone leaning or pulling on the door to prevent unlocking).
• Mechanical latch retraction by pin tumbler key cylinder–commercial or “Prison Mogul” types.
• Normally jamb mounted in a steel door frame (14 gauge minimum) in a specially fabricated and reinforced lock pocket (or mortar box).
• Lock mechanism can be accessed without removal from the frame via an access plate on the non-secure side of the frame.
• Impact tested to Security Grade 1 per ASTM F1450 and F1577.

Note: When used in exterior locations, moisture proofing of the lock enclosure is essential and an internal resistance heating strip is recommended when the lock may be subjected to extreme freezing conditions.

• Lock case and cover made of 10 gauge steel, electroplated for corrosion resistance
• Beveled latch made of saw-resistant hardened steel with a full 1” throw and 3/4” x 1-1/2” cross section.
• Cast stainless steel strike plate.
• Working parts are high strength bronze or stainless steel.
• Maintained Switch Latch Holdback (MSLH) function
• Lock status switch (LSS) trips when the latch is in a deadlocked condition.
  • Used in a signal circuit to indicate lock status – unlocked or deadlocked – via control panel lights and/or alarm devices.
  • The LSS is also used to control an electrical interlock, which permits only one of a group of doors to be unlocked electrically at any time.

Note: For positive, tamper resistant signaling of a closed and deadlocked door, a sensitive door position (DPS) switch must be wired in combination with the LSS. RR Brink DPS Nos. 201030 or 201090 are recommended.

• Models are Fitted for mechanical operation via either RRBLS proprietary “Mogul” or user’s commercial key cylinder.
  • For stop side only or both side frame keying, the frame manufacturer must provide stop (push) side cylinder access or optional “key cylinder extension” (KCE).
  • Key cylinder(s) must be factory assembled in lock.

Available Cylinder Finishes:

• Satin Brass (ANSI 606, US4)
• Chrome (ANSI 626, US26D)

Additional Features:

• Plug connectors are provided for ease in wiring and removal.
• Exposed fasteners – pinned “Torx” head

Electrical Data

• Motor – 24VDC, 1.0 amp or 120VAC, 3 amp
• Lock Status Switch – 125/250VAC, 5 amp, SPDT (Form C)

Want to place an order? Not sure what you need? Don’t worry... we’re here to help.

Call us! 1-800-661-5713